Discussion Locked

Upgrading Memory

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have two older PCs that can use a memory upgrade. What information do I need to know to get the right memory? One is a P133 with 4 memory slots and two are filled for 32MB. The other is a P233 with 3 memory slots and two are filled for 64MB. Neither PC is a brand name. Thank you

11 replies

by dmiles

PC manufacturer
Type of memory simms or dimms modules
PC bus speed
www.kingston.com to see memory reference

The first system probaly has simm modules,wich has to be loaded in pairs

The second system has dimms which may be upgraded using a single module,depending on the motherboard you may have to check the manufacturer's web site to see how much memory the board will support

by rgrowcock

The basics would be number of pins, 68, 72, 80, 168, etc. Motherboard capacity (how much it will handle) and whether the memory has Error Correction. ECC v. Non-ECC.

The P-233 would most likely have 66 Mhz, 168 pin DIMMS, in which case you could use PC100 or PC133 SDRAM DIMMS and it wouldn't hurt a thing.

The P-133, could have either EDO or SDRAM, I'm not sure on that. The easiest way to tell would be to look at its size, if it is short then it is most likely EDO. That is coming harder and harder to find, not to mention it's not cheap.

Depending on what you are wanting these systems to do, you could probably purchase refurbished systems off of Ebay or similar are fairly cheap. Depending on your budget of course. Just a thoughtand hope this helps.

Roger

by opatzg9

The 233 is likely the sdram and 66,100,133 would work as stated in the answers above.
The 133 is likely to be 72pin simms and then the ecc/parity nonparity is important to know. The used market has them in around the .50 per meg range, however I too would recommend getting a refurbished instead of continuing to hope the older computers stay running. Tigerdirect.com is another nice place to look for refurbs so is Krex.com
Good luck

by thechas

You can identify the motherboards from the BIOS string. (lower left side of screen at POST)
Then, go to either www.motherboards.org
or www.wimsbios.com
to look up who made the motherboard.

As stated, the 133 system likely uses 72 pin SIMM memory. This could be either EDO or FPM. SIMMs need to be installed in matched pairs.
It would be best if all 4 SIMMs were of the same type (EDO FPM) and speed (60ns 70ns)

You are somewhat limited in sources for SIMMs these days.
Check out www.compgeeks.com
www.computersurplusoutlet.com
www.pcliquidator.com
as they cary surplus hardware for older PCs.

The 233 may actually be more of a problem. While it sounds like it has 168 pin DIMM memory, many of these older motherboards are very picky about what DIMMs work in them.
I have personally experianced the following limits;
Only works with double-sided PC66 SDRAM DIMMs
Can only use the 3rd DIMM slot if all slots have 32MB or smaller DIMMs
Can only use 32MB SDRAM, but can use 128MBEDO DIMMs
Requires 4-clock-cycle DIMMs
Requires 2-clock-line DIMMs

The morel, find the specifications for the motherboard, or work with a local dealer who will swap memory modules with you until you find what will work in the PC.

Chas

This discussion is closed to new replies.