Discussion Locked

Upgrading my 733mhz P3 Slot 1 CPU? Help.

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Hewlett Packard Pavilion model 9600c that I had configured about 3 years ago. It has a P3 733mhz Slot 1 processor. I have upgraded the rest of the computer throughout the years but I would like to upgrade the processor now. What is the fastest that I can use. I have not been able to find a Slot 1 processor fast enough for me to do the upgrade. Would jumpers also need to be set or is is just a plug in? How do I know what voltage and other information to use. Please help me. I have upgraded everything in computers but this is my first time upgrading a processor.
Thank you,
George

16 replies

by rapidad

By the way, you may want to check current prices on ebay for your old processor and figure that into your total cost of ugrade, you should be able to net about 75.00 for it.

by lt1transamgt

Thank you. Since I really like the way the computer is set up now and dont want to buy a new machine I am going to go with the powerleap. Hopefully I will have success like you have had.

by maxwell edison

Your biggest consideration is your main board FSB (front side bus) speed. Intel Pentium III 733 Slot 1 is 133MHz FSB. So the fastest processor you could use would be a 933 MHz, which is the fastest slot 1 processor manufactured. (I believe that to be true, unless someone else knows about a different product.)

Here are a couple for around $150

http://www.streetprices.com/Electronics/Computer_Hardware_PC/Processors/Pentium_III/933_Mhz/SP369444.html

http://www.streetprices.com/Electronics/Computer_Hardware_PC/Processors/Pentium_III/933_Mhz/

This outfit claims to have the fastest Slot 1 upgrade - a 1.2 GHz. I don't know anything about this company or the product.

http://www.totalmem.co.uk/Store/itm00001.htm

REMOVE SPACES from the pasted URLs

by timwalsh

You need to find out the manufacturer of your motherboard and determine its specs. Your MB may or may not be upgradable as far as the CPU. You are limited to what your MB will accept.

From looking at the specs for your computer on the HP site, it looks like you could use up to a 800 MHz P3 in it. You would probably be safe upgrading that far

by opatzg9

Personnaly I'll look more into replacing the motherboard at this point so as to not limit your upgrading. going from 733 to 1.2 ghz isn't that great of a climb. There are combo cpu/motherboards out there with celeron 1.7 and 1.8's for around $170. They can come with as many onboard features as you would like. Take a look at tigerdirect.com for some ideas. Do you know what your power supply is? 300W or better? The Pentium 4 2.0 ghz cpu seem to be the current break point of cost hikes. Thereal question is how much do you want to spend and how fast do you want to go. Otherwise 733 aint to bad. I'm running a 900 mghz duron and it seems to keep pretty good pace with most anything else i've ran against. I'm considering upgrading to the 1.7 or faster whenever I decide to give my current pc to my kids. I'ld recommend just being careful not to overspend what your system is actually worth.
$600 nowadays buys a lot of computing power with a new operating system.
Take Care

by thechas

I have to agree with opatzg.

A new motherboard and CPU (likely a new case and power supply too) is a more worthwhile investment than a faster CPU.

At BEST, doubling your CPU speed will result in a 25% improvement in performance. This diminishes significantly once the CPU speed is more than 5X the front side buss speed.

I am assuming that the Pavilon has on-board graphics.
Moving away from integrated video, sound, and modems will give you a much better performance boost than a faster CPU.
Also, interface changes over the last 3 years will allow a new motherboard to leave your current system in the dust.
ATA133 IDE is double the ATA66 that you may have on your Pavilon.
The latest P4 memory buss speed is 533MHz, more than 2X theeffective rate of the RDRAM that was the standard in P3 days, and 4X faster than SDRAM.

Personally, I would go with an ABIT or ASUS socket A motherboard, and a 1.6 GHz or so Athlon XP CPU.
For around $250, you could have a decent system with allthe DDR ram that your OS can support.

Chas

by mmerritt

Having researched a similiar upgrade for one of my computers, I have to agree for the most part with the previous answers to your question. The fastest and cheapest CPU I considered was a 1.2GHz PIII for @ $125.00. With barebone systems in the 1.2->2.0GHz range costing @ $200->$300, I decided to hold off and save save my money because the CPU upgrade wasn't pratical at this time. Depending on what you wish to accomplish with an upgrade to your system, I don't think there is anything a 1.2GHz CPU can do that your current 733MHz CPU can't do, only slightly slower. How much memory does your computer have? If you don't have at least 256Mb or more, now is a good time to get it while it's cheap and will greatly increase performance. If after trying to talk you out of upgrading your CPU, and you decide to go ahead and replace it, I would definitly be interested in takeing it off your hands for a fair price, to replace my CPU!

by rcom

This unit will only take up to a 800MHz CPU. That's a no go. I'd spend money on upgrading the memmory and video card. You'll see more improvent this way than with the CPU. Other than that I would get the barebones system and either rape this one forparts or sell it. It should be a pretty good machine. There isn't much you can do as far as upgrading it.

This discussion is closed to new replies.