Discussion Locked

Upgrading Ram

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I currently have a HP system with 128mb of pc100 sdram and i want to upgrade and put a 256mb pc133 sdram but I am wondering if the 256 pc 133 will interfer with what i have or should I just get a 256 pc100 any suggestions?

7 replies

by estebandelatorre

It all depends on the motherboard type and model. Hp will said that you have to buy it's part number, bla, bla, bla, that the warranty, etc, etc and so on.
Generally the lowest speed memory should be seated into bank 0, and the other memory PC133 (into bank 1) will be treated as a PC100 speed.
Go ahead !

by centaurus

The only thing that you have to concern is if
both modules are cas2 or cas3. To avoid compatiblity problems its advisable to have modules of the same brand, althoug i have used diferent modules for several times and never had a problem.
Regards

by otl

Answer #1 and #2 are correct, of course using different ram speed open you up to fatal error OD: (on board equipment error) and using different manufactors RAM (sometimes even the same) opens you up to fatal error OE: (software error)

Problems occur when Syncronization occurs at different times or speeds and one of the clocking sources differ from what is suposed to be the master.

This discussion is closed to new replies.