Discussion Locked

Upgrading to a 40GB HDD

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Pentium II 300mhz PC running a 3GB HDD. I have just bought a 40GB HDD as a replacement and each time I try to boot up with my new drive, the 40 GB disc drive is not detected. Do I need to do something in my BIOS or CMOS to enable my PC todetect my new drive?

7 replies

by ann777

You need to make sure that the jumpers on your old hdd are set to master, and the jumper on your new hdd is set to slave (usually a newly purchased hdd will be set to master).

Then connect the cables and power on the computer. It should automatically be recognized in your bios, but if the jumpers are set wrong then it won't be seen.

Then insert the floppy disk that came with the drive and follow it's directrions.

Then format. You should be okay at this point. Sounds like the problem is the jumpers.

by leebenham

I only have the new HDD in my PC now and the jumper is set to master. Unfortunately when I boot up, I get a message...detecting Primary disc drive, press F4 to skip. Nothing happens and F4 doesn't work. When I put my old drive back in my PC, it works fine. Would I need to clear CMOS? or wouldn't this make a difference.

by mskiproductions

Have you tried going into your BIOS, and making sure it is set to autodetect. Some sytems are set up with the BIOS manually configured for the hard drive you got with the system.

You should find a page that should look like this, if it doesnt chage it so it does.

Primary Master - Auto
Primary slave - Auto
Secondary master - Auto
Secondary slave - Auto

If not, i'll do a bit of research to try to sort it out.

Matthew Shine

ComputaCenter, Europe

by dmiles

Check the bios version and year on the post startup screen,if over 3 years you need to up grade the bios.
The BIOS may not be detecting the drive because of the size,you need to flash the BIOS to upgrade or use the hard drive software to install the overlay,that will enable the bios to read the drive.
On the other hand check that the cable is set on the drive correctly and then open your CMOS control panel to the BIOS,on the Configuration list,enable master to Auto,now format the drive with operating system disk

This discussion is closed to new replies.