Discussion Locked

US Robotics Fax Modem problem

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've installed a US Robotics Fax Modem
56K PCI on a computer running Windows
95 (not 95A). When I click on the modem
in the modem control panel, get
properties, click on the Diagnostics tab,
and choose Get Info, I get an error
message tothe effect that the modem is
not responding.

I've been through all the troubleshooting
suggestions and have talked (once) with
US Robotics Tech Support, who
suggested uninstalling all associated
software and starting all over. I did that, to
no avail.

Any ideas greatly appreciated.

Mary

7 replies

by dcosgrove

Try doing the same in safe mode. Go into the device manager and remove all entries under the modem icon, sometimes there may be things like "parrallel cable on lpt1" etc. Remove all of them and reboot into normal mode and see if it detects, installs and works better.

by buffalodan

You should actually go into device manager from a normal boot and look for devices that have a yellow exclamation mark over them. Also, you might have an entry for "OTHER" with PCI commuinications device under that. If so, this PCI Comm's device should be removed.

Another thing to look at is your System Bios.

Many BIOS' like to have serial ports set as Auto, If so I would consider either forcing serial ports to com1/com2, or if this is no help then disabling the second serial port altogether.

Another STRONG recommendation....make sure that all patches and updates for win95 have been installed.

Visit this website: (entered exactly as typed)

"windowsupdate.microsoft.com"

click on product updates, and download and install the updates.

Windows 95 was not very adept at auto management of serial devices, of which your modem is one.

Good luck with this.

by grump

Mary,

First check device manager and see if you modem has the all so famous ! point. If so you will need to find what resources Windows as setup for this device and check the resources of other devices to ensure there are no conflects with the different devices.

I find it is best to leave the on board serial port in auto or asign them 3F8,4 and 2F8,3 simply because windows will detect them and asign resource to those device. I you BIO/CMOS will shut off the UART completely so windows doesnot detect and comm device OK to disable in CMOS other wise best to leave them in the basic..

Next thing I have found is a good many sound cards /pci and ISA utilise multiple resouse setting and multiple IRQ's this will limit the rewource for any modems. Many modem are program for a range of resorces that can be utilized and when windows asigns resources outside of that range you will get an error
message to the effect that the modem is
not responding. I have spent many hours getting modems and sound cards setup in the same computer..
Remove the modem completely from the computer. Next remove the modem in the control panel under modems.. check device manager an make sure that you do not have any modem or pci communication device listed..
Boot up you computer and shut down normaly.. power off each time.. Next install the modem in a different PCI slot.. IRQ's are asigned in a slot order for PCI this will change the IRQ asigned to the modem. After the modem has been installed go to the device manager and check the resources asigned to the modem.. Then off to the control panel to diagnose you modem installation...

Good Luck.. and the FORCE will reconize you as the GREAT MODEM EXPERT!

Grump...

This discussion is closed to new replies.