Discussion Locked

USB 2.0 H/W requirements?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a USB 2.0 capable mobo and am adding ports to my headers. I was wondering if there is a difference in the actual HARDWARE between USB 1 and 2? IOW, if I install some USB ports into the back of my machine (via factory-supplied headers)will the"plugs" support both versions, or is there any difference? (They have no markings on them). Looked around online for awhile and couldn't find much. Thanks...

5 replies

by patternflyer

Here is a link that may help you.
2.0 is fully backward compatible, so you can use any 1.x devices there. Remember they work slower. However, connecting of new 2.0 devices to 1.1 is prohibited. There is no plug differences to be backward compatible.
http://www.everythingusb.com/usb2/faq.htm
Hope this helps,

by thechas

I assume that you are referring to the actual cables that run from the motherboard headers to the USB port connectors.

Technically, they are compatible.

On a practical basis, some cables may not be able to support the faster USB 2.0 data speeds.
If you get data errors, or have problems using true USB 2.0 devices on the ports, the cables themselves are the likely cause.

You may be able to help the performance by twisting the 2 data line wires together.
1 twist per 2-3" should do the job.

Chas

This discussion is closed to new replies.