Discussion Locked

USB Front Panel cable

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I replaced my mainboard and cpu. The cable from the existing case does not match the mainboard connectors for the front USB connectors. No one seems to sell these independent of the case and it looks to me like trying to rewire is a destructive process (either I destroy the connectors tying to get them out of the plastic block or destroy the plastic block). Anyone know where I can get an "Intel USB" cable or how to rewire the existing cable?

7 replies

by thechas

Wouldn't it be nice if there was a common standard for how USB headers are configured.

The cases I have with front panel USB have cables with individual pins for each wire.

It is possible to re-wire most USB cables.

What you need to do, is to CAREFULLY press down the catch portion of the pin with the correct size tool, and remove the wire.

(A paper clip works for most pins.)

Do NOT press too hard, or you WILL damage the pin.

How does the cable connect to the front panel?

Ifthere is a header at both ends, you can buy cable parts from either Hosfelt Electronics or Digi-Key.

www.hosfelt.com
www.digikey.com

If the cable has a molded plastic covering, your best option is going to be to build your own cable.

Chas

by pctech

The pins are held within the plastic block with a little tab along the side of the pin. Look closely and you will be able to see it. Gently lifting the tab, with a small pointed object, with allow you to slip the pin out of the block. If the pin outis written on the side of the block, record which color wire connects where on the block and match this to the pin out on the motherboard.
I hope this helps

by al

I did actually figure out myself that I could lift the little plastic tabs and remove and reinsert the connectors but thanks to PCTECH anyway. The mobo Tech Support people told me the board was "standard" Intel pin placement and I found that layoutat "directron.com" thanks to good old Google. so it is working and the user is happy.

This discussion is closed to new replies.