Discussion Locked

usb hard drive problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I took an 80gb hard drive out of a dead system (hd was ok, mobo went bad) and installed it in an external box with a usb connection. I want to use it as a backup hard drive. problem is, my winxp sp2 box will only see 31gb of the drive. anybody got a clue for recovering the whole drive short of tearing the pc apart and installing it in the box?

9 replies

by absolutely

If you can move any data on the drive to the hard drive that is already installed, there is a simple solution. Open Control Panel, then Administrative Tools, within that Computer Management, and use the Disk Management tool to delete the volume, and reformat, hopefully giving you the entire 75GB that Windows recognizes in an 80GB drive.

by ghimpe--

"... my winxp sp2 box will only see 31gb of the drive."

Strange :(

The best thing yyou could do is to format the drive. In My Computer just left click and chose format :D

BTW, is the drive IDE or SATA??

by ghimpe--

Although unlikely, maybe the USB enclosure has a controler that suports 32GB max?? Have you/can you use another hard drive bigger than 32Gb in this enclosure??

Try the hard drive conected directly to the IDE controler on your mobo. If that doesn't work either it's time to visit the drive makers homepage and download the diagnostic utility.

GooD LucK!

by hal 9000

Have you checked the jumper setting on the drive?

Some drives have a size limitation of 32 GIG and since you are seeing 31 GIG that sounds very much like what your problem is.

You will need to have a look on the makers Web Site to see how to set the jumper/s and then try again but if the size was limited to 32 GIG you'll most likely have to use something like Partition Magic to either create another partition or resize the existing one.

I hope that is of some help lets know how you get on.

Col

This discussion is closed to new replies.