Discussion Locked

usb hard drive problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I took an 80gb hard drive out of a dead system (hd was ok, mobo went bad) and installed it in an external box with a usb connection. I want to use it as a backup hard drive. problem is, my winxp sp2 box will only see 31gb of the drive. anybody got a clue for recovering the whole drive short of tearing the pc apart and installing it in the box?

5 replies

by david

did the hd come out of an old pc if so did you ckeck the jumpers on the harddrive or have you had a look at the hd makers web site for hd utils

by morocco_mole

it was an errant jumper. apparently this hd has a "limitation jumper" you can set if your system can't take anything larger than 32mb without crashing. I had no idea it was there till I went to the website looking for a utility.

thanks for the tip...

by reefurbb

1. is the 80gb formatted ntfs, same as current Hdd? Is there lots of stuff on it from old dead PC? What are the 60gb jumpers set for? Some (Maxtor) require no jumpers for single master.
If the old PC saw 80gb with no extra partitions, you're halfway home.
2. what is the current Hdd size? re: can your mobo recognize 80gb? You may have to reset BIOS (setup) for default first, then optimum later.
3. device drivers, IDE controller, may be an issue with the external caddy. Check the mfg website, firmware updates, and user manual. Check Device Manager to see how the controller is listed for the USB external caddy.

This discussion is closed to new replies.