Discussion Locked

USB printer problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Two of my clients have the same problem: they both have Lexmark printers (differents models) and every time they boot WinXP appears the Add new hardware wizard. I tried upgrading the printers software, disabling the bidirectional property of the printer and a lot of other things that didn't work. Could it be a Usb problem? any ideas?

Thanks!

4 replies

by jschein

Are they logging on as admins or users? logon as the user with admin rights, re-install the software, reboot, take away admin rights... should be good..

by tiza

i will tell you one thing, after using lexmark printers in our org for sometime, i just decided i would better spend a little bit more and use other models. personal opinion. anyway, try removing all traces of the printers from the pc's (unstall all software), un plug them, reboot, then reinstall the software. powerdown again, connect the printers and let the pc find the printers and install them. this may work, as it worked several times on one of my pc's.

by rcom

Agree with tiza that the software and drivers need to be installed before the printers are connected. But often with USB devices there may be a specific time during the install that prompts for the user to connect the unit.

This discussion is closed to new replies.