Discussion Locked

USB problems

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My friend has just bought a Packard Bell pc with 4 usb ports, 2 on the front and 2 on the back. One is used for the mouse/keyboard, the other on the back we tried to connect a scanner to. The scanner software is installed properly but it cannot findthe scanner. When I swapped the scanner usb with the mouse/keyboard, a message came up saying a new device has been found, but the mouse/keyboard won't work. The system is running Windows XP. The scanner is Visioneer. Do you have any ideas?

3 replies

by thechas

Make sure that all ports are enabled in BIOS settings.

For the front ports, make sure that the cables are connected properly.

Next, make sure that you have any required XP updates installed.

Chas

by timwalsh

If all devices work in the one USB port and none will work in the other, the most obvious answer would be a bad USB port. Another possibility might be that the one non-functioning USB port could have been disabled in BIOS (although not likely, thisis a Packard Bell we are talking about - so who knows what wierd things might be going on). Have you tried connecting the scanner to one of the USB ports on the front?

by nccorthu

If the previously suggested Bios setings are not involved then try a USB Hub. The unpowered $4 on E Bay version might do just fine. Its easier than trying to make the one port that won't , work.

This discussion is closed to new replies.