Question Locked

USB to IDE/SATA Cable, XP won't recognize hard drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a USB to IDE/SATA cable. Plugging in a cd-rom externally it is recognized by my laptop HP DV4000 running XP with sp3 and works fine. I have tried hooking up two different hard drives to it, but they are having problems. Neither drive shows up in my computer or Windows explorer. However they do show up in device manager as a USB mass storage device. How can I get my system to recognize tese hard drives so that I can utilize them.

Thanks,
Bill

7 replies

by ic-it

Open Disk Management and right click on that device, assign it a drive letter.

by wsmmm03

Drive shows up in device manager, does not show up in disk management, my computer or windows explorer.

by bobcito

I am having the exact same problem, where you able to find a solution?

by oh smeg

If they do not you need to format them by Opening Drive Management and right Clicking on them. You may be asked do you want to Prepare this Drive for Formatting and you click on the Yes Option then when that is finished follow the Prompts. If you are not asked all that you need to do is Right Click on the Drive scroll down the Drop Down Menu and select the Format Option and then follow the prompts to format the way you want the drive to appear.

Col

by wsmmm03

Problem is resolved, but I can't give a valid reason as how. After not being able to read the first dive I tried a second I had from a laptop, still no results. Called the company and they had me try setting everything up again and with no luck, they said send it back it may just be a bad unit. Decided to try one more thing, hooked up a CD-Rom read only drive and it worked perfectly. I then went back and tried the hard drives again. This time it worked on 2 out of 3 drives. The drive it didn't work on was very, very old probably close to 20 years old so I'm writting that failure off to the drive. Wish I could give you an answer, but I don't have one.

Bill

by bobcito

The answer is to change the setting on the drive from Master or Slave to "CS". Cable Select.

This discussion is closed to new replies.