Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE A GATEWAY SOLO 2300, I HAVE UPGRADED TO A 6GIG HD, I HAVE PLUGGED IN MY EXTERNAL CD-ROM TO THE USB, FIGURING THAT I COULD GET THE SYSTEM TO BOOT, BUT NOTHING HAPPENS.. I HAVE TESTED THE USB AND THEY ARE ALIVE,BUT THE COMPUTER WON'T ACKNOWLEDGE ANYTHING.. HOW DO YOU SETUP THE BIOS WHEN THERE IS NOTHING TO ENABLE... GATEWAY2000 SOLO 2300...
5 replies
by kc 1
you can flash the bios that is EPROM using an ultraviolet light that clears your system configurations on the chip and load in the new data . There is also eeprom . For specific instructions check out
by l2sed
The question was auto-closed by TechRepublic
by wlbowers
To answer your question. Some machines will not boot from a usb or firewire connected drive. The drivers are not in hardware.
You can get an adapter that will let you put your laptop hard drive on a desktop system. This would allow you to copy the image of your old drive to the new drive. Do a Google search for 2.5 drive adapter
I read the question.
Good Luck Lee
by l2sed
The question was auto-closed by TechRepublic
by l2sed
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies