5 replies
by emrecall
Follow all the usual precautions before you crack open your box and start working on it. Set the jumpers on the second hard-drive to the slave setting (look for a diagram on the drive or check the manufacturer's website for the jumper layout) and set the other hard-drive's jumpers to the master setting. Connect them using the same IDE ribbon cable (most have thee plugs one for each drive, and the third to connect to the motherboard). Close the box and restart the machine. The bios should automatically recognize both drives. If not, go into the CMOS setup and set the IDE settings to automatic. After your OS starts up you can partition and format the second hard-drive and use it purely for storage. Check out Western Digital's knowledge base on disk drives, it's fairly generic even if you don't have WD drive. Here is th elink: http://support.wdc.com/techinfo/general/jumpers.asp
Hope that helps.
by catmouseu2
by thechas
In addition to setting the new hard drive to slave, (if connected to the same IDE channel as another drive)
You may need to change the jumper setting on your existing drive. Many hard drives have different settings when used as a single as oppossed to a master with slave present.
If you have multiple partitions on your existing drive, and want to keep the drive letters from changing, partition the new drive as an extended dos partiton, and create logical drives.
Your CD and removeable storage drives will be assigned new letters.
Chas
by catmouseu2
by catmouseu2
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending