Discussion Locked

Using a Firewire Hub

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can a Firewire (IEEE-1394) hub be used to take an output from a digital camcorder and send it to 2 computers, with both computers getting the same quality signal? For clarity, this is in regards to a PC system, not a Mac. Thanks.

3 replies

by alquinones

A hub by design will break up the signal and pass it on until all devices receiving the signal are done. This process continues until the one of the devices are/is disconnected. Whether or not a Firewire hub is fast enough to give you a good refresh rate on your monitors is a different story. You may experience ?jerky? motions. Also your camcorder may suppose this type of setup. As long as the signal from your source is digital it may work. Good Luck.

This discussion is closed to new replies.