Discussion Locked

Using a Monitor With Laptop

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Compaq Presario 1700XL275 with an ATI Rage Mobility 8mb (has s-video and monitor outputs). The s-video works great with a TV, however, the monitor output does not work with a monitor.

I have tried several monitors. I know the monitors are good, connections good, and power is on, but no signal is given from my laptop.

Friends have suggested using the Function Key (nothing works) and a bios setting (no display settings found). And there is nothing that I can find under "settings" when right clicking on the desktop. (Running Win XP) And I have done a clean install with XP, so I do not have any Compaq crap on my hard drive (although the Compaq crap is probably what I need to make this thing work; though I have no other problems).

Any advice will be much appreciated!

Thanks,
Ben Snyder

17 replies

by ben

I'll check the website. Yes, I did make an upgrade from Win98 to WinXP. I also dumped all the Compaq proprietary junk when I changed hard drives too.

by dmiles

This scenario may be that the monitor is not supported by or recognized.

Using the fucnction key is alternative to giving you a display setting to switch the screen settings to the monitor

Check the manual to see how this function is setup,it may be that the monitor software has to be installed,try downloading the drivers from monitors manufacturers site for XP drivers

by ben

The function key does not work in switching to an outside monitor. I don't have a manual specific to my monitor, and the Compaq manuals I have do not speak to this issue. Last time I checked I did not find any new drivers for the video card and XPissues.

by paulp

I'm not familiar with the model laptop you have, but years ago I had a similar problem.
In addition to plugging in the monitor, I also had to use an external keyboard and mouse before the monitor would work.

by ben

I haven't tried the external keyboard and mouse with the monitor to get it to work. What exactly is the logic behind that? (Please don't take that the wrong way, I am seriously interested in why that would fix the monitor issue)

by madmark

Sounds like you need to check your ATI drivers and software. I'll bet the ATI card came with special software... There may also be a special key combination, like Ctrl+F7, to get the secondary monitor output to work. Similar to a notebook with LCD and external monitor hookup.

by ben

Your comments sound fairly accurate as to the heart of my problem. The key combinations do not do anything, and the ATI drivers are not available from ATI for my video card. Their reasoning is that each laptop manufacturer specially modifies theirdrivers to get the card to work with their particular setup, and thus won't release "generic" ATI drivers to individuals. Go figure.

by ben

I'll have to go into BIOS again, but the last time I went in, I found nothing relating to external video ports.

by gigelul

Hi,
My conclusion is that WinXP don't recognize correct your hardware (motherboard). I'm afraid that you can't resolve this problems without special drivers from Compaq.
I had the same bad experience with a Compaq Presario desktop, when I upgrade it from Win95 to WinNT (I can't activate some special buttons from case panel - Launch IE, volume control, standby).

by gigelul

Also if you don't have a response from system when you use special key function from keyboard, this is other issue related to WinXP.

by ben

Although I hate to admit it, I believe you are probably right. Although your answer is "correct" it didn't solve my problem. Thanks for your input.

This discussion is closed to new replies.