Discussion Locked

Using AT commands

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how do I issue an AT command (AT H0) to my modem. I have an application that leaves the com-port open.Ive tried doing it through HyperTerminal but not exatly shure how to go about doing it. (win98 os)

5 replies

by heil

Find out which comm port the modem is installed upon. Usually you can check in the control panel under the modem section.
Open a new configuration using hyperterminal and select the comm port for the modem. Use the default settings and connect. Type 'AT' and you should see 'OK' as the response. You can type in your modem commands at that point.

by pvp

The first answer is good, but if the modem is in data-mode, you need to get back to command-mode first.

Type '+++' (no quotes, no [Enter]) to get to command mode.

This discussion is closed to new replies.