Discussion Locked

using udma 133/166 on old motherboards

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have EP-8KTA+ which supports udma 33/66. The present HDD needs to be replaced. Most HDD now come as udma 133/166. I know I can use a control card but can the HDD udma 133/166 still be used unspported. I apreciate that there will be a loss but as the present PC will be soon replaced, I do not want to buy a control card.

7 replies

by timwalsh

You have a couple of choices her to get your answer:
1. Someone else who is using this motherboard will tell you it worked for him. However, unless the other person is using the same configuration and drives from the same manufacturer as you, youstill won't have a definitive answer. I would suggest talking with Epox Tech support. They are more likely to know of any issues with either specific issues relating to bus speed or with specific drive manufacturers.
2. Experiment. Buy a new drive and install it. If it works, you're in luck. If it doesn't, then you know you need to get a new controller.

I have in the past (in one specific case) had a problem where a UDMA 133 drive would not work on a udma33 motherboard until I installed a new controller. This is not an indicator that you will have problems.

Good luck.

by thechas

I recommend that you go ahead and add a PCI ATA 133 controller card into the PC.

If for no other reason, than the double data transfer rate that you will get.

For around $30, you get the full performance of your new drive, and 4 more IDE portsto boot.

This way, you can have your CD-ROM and CD-RW drives on separate IDE channels.

Chas

by dclark_billericay

I agree, however it's not my cash that I will be spending. I know it's not much but I am trying to keep the cost down for her. Thanks for advice.

by cg it

This is to add to TheChas's answer. SOME! [note: SOME, not all]ATA/UDMA-133 hard drives are downward compatible with UDMA 100/66/33. Hard drive manufacturers do this to be able to sell their hard drives [not everyone is going to buy a new motherboard, or build a new system, just to be able to use a new hard drive]. If you current mainboard is UDMA-66/33, and assuming that it does recognize your drive, then the fastest data rate between memory and drive is 66 mbs . As TheChas said, get a controller card so that you can take advantage of the high data transfer rate.

This discussion is closed to new replies.