Discussion Locked

UTP direct linking?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to connect two PC directly using UTP cable where both PC has it own network card
install(RJ-45 connection).The problem for me is I would like to know will it be posibble to
connect two PC using a crossover cable or using straightthrough cable or you can suggest
a good way to me how to position the 8 wire inside the UTP for me to make direct connection
between two PC network card.
Please advice.
Thank you.

7 replies

by william jay

OK, direct connect between two computers requires at least one network card in each machine and one cross over cable.

To make one from scratch, install the jack as normal on the one end and on the other, cross the ring pairs 1->3 and 2->6 ...

by holt

You need to use a crosover cable to connect 2 PCs without a hub or other networking device in between.

If you don't have one, you can make it by pinning as follows:

12345678
36145278

by ridire

The 1-3 and 2-6 crossover cable above is correct, but just a bit of advice from experience. If there is a large distance involved here, you might want to make a long striaght cable, slip in an in-line coupler and then a 18-24" crossover pigtail to the NIC. As your network grows, and they all tend to, you add a hub or switch and this way you need not reterminate, and are not toting around a 100' long crossover cable that you have no use for! Especially handy if you are buying extended patch cords rather than making your own!

--Paul

This discussion is closed to new replies.