Discussion Locked

V90 56K fax modem connecting at 28.8K

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was using a 28.8Kbps fax modem for dialing into the internet. My maximum connection speed was around 33kbps. Now I installed a V90 56KBPS PCI data fax modem card and I can only connect at 28.8max. I am still using the same physical cable line.
How can optimize this modem

9 replies

by searogue

Hi, the first thing to check if you haven't changed it yet, is to make sure you changed the modem in your dial up properties, make sure it is set for using your new modem & not the old one.

HTH

Best Regards,

Tony

by renegade99

In order to connect at v.90 speeds you need to make sure that:
1. you are connecting to a v.90 access number with your isp-if your isp is not v.90 capable then you will have nothing but headaches trying to connect at speeds higher than 28.8
2. youhave the most updated firmware/drivers for your modem(check your modem manufacturer's website for any software upgrades). You can check the firmware version that your modem is using by going to the control panel, modems, click on the diagnostic tab,click on the com port that your modem is installed on, click on more info. Check the version number beside the command ATI3. Verify that there are no higher versions available on the modem manufacturers website.
Hope this helps

by csmith

Start with this Website
www.808hi.com
The 28.8K modem could not modulate over 28.8K
The 33K is due to the compression.
Most internal PCI Windows modems are controllerless.
This places a heavy load on the CPU, this is apparent especially if you are using a 486 with a PCI bus.
Test the modem speed against the website, and troubleshoot from there.
Regards, Chris

by scusack

You have been answered by several different solutions but one thing that helped my connectivity was changing the BAUD rate in the win.ini. There are settings toward the bottom that default at 9600. Bump those higher on the com port the modem is on.

This discussion is closed to new replies.