Discussion Locked

Vanishing CD-RW on Compaq Presario 5630

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Odd situation here... I've got a client with a Compaq Presario 5630. It has one CD/DVD drive, a 12GB IDE and a 40GB IDE drive. So, that leaves one IDE channel free, right? Well, we add an HP CD-RW drive to his set up and we power it up. WINDOWSsees the drive, but CMOS does NOT! When I restart the machine, it doesn't show up (unless there is a CD in the drive, THEN it sees it) ... And it won't work for burning. Run the software (Roxio) and the RW just goes into la-la land. No response. You have to actually turn off the machine for it to start properly... I know it has something to do with the CMOS settings (I'm pretty sure) but when I enter the BIOS setup, it just has options for "Primary IDE" and "Secondary IDE" and it just to turn them on or off... Nothing about devices hooked up to them... Any ideas?

thanks in advance!
Joe

1 reply

by danpiers

A couple of thoughts on the subject. First, CD-ROM drives should not be entered in the CMOS setup function. The system should identify each item connected to the IDE ports during the boot-pu sequence. Second, It is best to arrange the four items you mention in a specific order: Put both hard disks on the Primary IDE channel and bothe CD-ROMs on the Secondary IDE channel. Make the CD-R/W the MASTER and the DVD the SLAVE. Third, once in Windows, open the DEVICE MANAGER and go to the properties of each CD-ROM drive. Under SETTINGS for each drive, un-check the DMA checkbox. Re-boot the system and see if it works any better. You may have to un-install, then re-install the ROXIO software. Good luck.

This discussion is closed to new replies.