Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an AMD 900mhz ATX with 256MB of ram with a GA-7dx motherboard and running XP Pro. Recently I made the mistake of plugging my GPS into the serial connection while the machine and GPS were on. The computer blew up. When the computer rebooted the bootup process went fine until it went past the XP loading screen and the monitor went blank although the light remained green on the monitor. I discovered after booting in safe mode that if I disabled the video card (LeadTek Nvidia GeForxce 2 MX on AGP slot) in the device manager the computer worked fine albeit without the 3D accelerator working. I thought I had blown the card so I got myself a new one and last night while installing I could not load the card properly. XP informed me that thecard was not loaded properly because of invalid data and warned me the card may not work properly. I enabled the card after that and poof the machine did the same thing as it did with the old card. Only now I cannot get it to go into safe mode with the new or old card. I see the bootup until the XP loadin screen and I cannot force it into safe mode. Do I have a blown AGP slot? Thanks, Joe
5 replies
by guruofdos
Plugging in a serial device with the power on will NOT usually damage the computer, unless you have a faulty serial device that is producing strange voltages on it's pins i.e. it is electrically faulty. What has more than likely happened is that you'flexed' the motherboard and something shorted out. What you have is a problem where the driver isn't loading properly because there was a problem booting the driver at some stage and it has been dynamically disabled in the startup, similar to Windows 98's ASD function. It is VERY unlikely that your AGP port is shot but it is a possibility. Try a PCI graphics card and see if that allows the machine to boot to safe mode.
by jschmitt
Poster rated this answer
by thechas
It would be very difficult to damage the AGP port from the serial port.
However, you may have damaged the PCI bridge, and thus the communications between the AGP port and the CPU.
Start by setting your BIOS settings to factory default, and see if the video works any better.
Next, try installing / re-installing the AGP mini-port driver for the chipset on the motherboard from VIA or AMD.
If that doesn't correct the problem, I would seriously consider replacing the motherboard.
Chas
by jschmitt
This actually turned out to be a software problem. I was convinced it was the motherboard but before I started to tear my computer apart, I put in a PCI video card and got the same response. I booted off the XP CD and repaired and reinstalled XP and everything is back to normal. Thank goodness it had not been too far since I last backed up. Thanks for all your help.
by jschmitt
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies