Discussion Locked

video-resolution-troubles

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

video-frequency-troubles
i still do not understand the relation between the frequency in windows and in the monitor.
when i change to a monitor which has lower resolution is the adapting-procedure the same as if its vice versa(windows has lower resolution than monitor. i always have to go in with f8(safe mode) and make the changes. do i have to increase windows-resolution to the monitor or bring the monitors higher res. down? or can i decide?

10 replies

by bchesmer

If you have both your videocard & monitor installed correctly (That is both are identified by your OS) only the supported resolutions are displayed.

If this is not the case, you must determin what your monitor will support, and chose the best option from the listed display settings.

by parvus1202

How big is your monitor? The bigger the monitor the higher the resolution and the frequency. You cannot put high frequency on a small and old monitor. Even older but bigger monitors sometimes need lower frequency for safety purposes. If you put 65 mgz on a 21" monitor you will have flickering that will be very painful to the eye. Refer to your manual, there is always precaution written.

by europanorama

you misunderstood me. resolution setting are correct, the only problem is if monitor1 was originally setup on a 486-pc with 480x640 and monitor 2 was setup at 728 x1024 on a pentium. then i take monitor1(480x640) and want to use on a third pc which has 600x800. plus use monitor 2(728x1024) on a forth pentium with 600x800 too.
what should i do in each case or is there a general rule? do i have to level resolution to the lower setting or can i use the higher. all resolutions mentioned are withinthe limits.
one major problem occured today when i was unable seeing ok-button on lower-right corner. window was too big, resolution at 480 x640. what can i do to save the settings?

by bchesmer

As long as the monitor can handle the resolution that you want to set it to on the PC, there is no problem ;-)

by europanorama

i have 14 and 15 inch-monitor which can handle resolution between 480x640 and 768x1024. the main question is still unanswered. with a certain 14 inch momnitor resolution was 480x640 and i could not reach the ok button to synchronize the monitor/which was previously set to a higher resolution on a second pc. the setting-window was too big.

This discussion is closed to new replies.