Discussion Locked

Virus or Hardware?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a pc that has the W32.Bugbear@mm virus. It has Windows 2000 pro installed. The harddrive was brought to me after it was not able to boot to windows. The problem has gone from not seeing the C: drive to the CMOS not seeing the harddrive at all. Any Ideas?

8 replies

by rapidad

A little more info please........

1. CMOS not seeing the harddrive at all
this can be caused by the cmos not recognizing newer drives. is the cmos in the machine that originally carried the drive or one of your test boxes? Assuming you added it to a mother board to check it out, did you add it as slave/master/cable select?? cable select will not work in most cases. Let us know how you did the test...

2.it was not able to boot to windows
if you added this drive to a functioning box, chances are now good that the new box has the same virus. careful here.

3. You sound like you are in charge of an IT dept, remember your time is way more valuable than the fifty bucks needed for a new drive, unless it turns into a data recovery operation.
let us know.............

by rapidad

Tell us if the data needs to be recovered, this is where the path bifurcates, as what to do now.

1. data not needed, a good disk program like drive pro or its cousins will wipe out the mbr and first ten cylinders, hence getting rid of the virus. then using an nt or w2k cd to boot from will aloow you to rebuild the drive with a fat32 or ntfs (if you are going to nt).
2. Data recovery needed, this is much more difficult, requiring a second machine with w2k and a good antivirus software:
letus know which it needs to be.........
let me digress here...if your antivirus software does not update its signature files at least once a day, it's not worth the effort it takes to push the delete key. If there is a question in your mind about viruses go to
www.cert.org

by rapidad

I'd go ahead and wipe them clean at this point unless you want to go through the drill of recovering data, let me know and if you do I'll walk you through it.

by exp

sound like you might have a faulty HDD because you said the CMOS/BIOS can recognise it. Try it on other PC if same problem then replace it.

by girlmf

A little more info...
The drive was brought to me not able to boot. The person working on it had installed it to their machine and infected there own drive before bringing it to me. Both Drives have gone from booting to not booting then to not being detected at all in the CMOS. The virus was the initial cause but the drive has not be tested in another pc yet, I did not want to infect another BIOS (if thats the case). I suspect that the BIOS needs to be reset.
Thanks

by wlbowers

The virus that you refer to is a polymorphic virus that if left to itself will run rampant through a hard drive.

The worst infection I have found was 722 infected files.

Put this drive on a machine with no other drives installed. Set the jumper to cable select.

Boot to a locked floppy and go into cmos. If the drive is recognized exit cmos and at the a: prompt go to c: and verify there are files present.

If everything is ok to this point here is the next step.

Put the c: drive back on this machine jumpered as cable select. Do not have the infected drive hooked up.

You will need to make sure the virus software is active with the latest definitions.

Not connect the infected drive and d: cable select and boot the machine. Do not access the infected drive.

Start your antivirus and scan the bad drive. Again if everything goes right you will find a ton of infections.

If you can't get the drive to be recognized at all you have a hardware problem.

Good Luck Lee

This discussion is closed to new replies.