5 replies
by thechas
First, which version of Windows are you running?
Vivitar only offers a driver for Windows 95/98 for the Compact II.
The scanner does look a LOT like a Mustek 600 series scanner.
So, perhaps the Mustek driver will work.
http://www.mustek.com/Download/driv_scanr/html/english.html
Remove any spaces from the pasted link.
Also, make sure that your parallel port is set to ECP/EPP mode.
You do this in BIOS setup, which is entered by pressing a key (Del) when you first turn on the computer.
The printer port mode setting will be on the integrated periphials page.
If you have downloaded the Vivitar driver,
http://www.vivitar.com/CustService/drivers2.html#Scanners
You need to use a program like WinZip to extract the driver files from the archive.
I recommend extracting the files to a unique folder.
Then, run the run.exe file from the new folder.
I would run the program.
Shut down.
Connect the scanner,
re-boot.
The scanner should be the first device connected to your parallel part.
Depending on the scanner and printer, the printer often needs to be turned on for the scanner to work.
Chas
by neely
by ann777
Did you try these drivers:
http://www.scanner-drivers.com/drivers/43/43199.htm
http://www.scanner-drivers.com/companies/1128.htm
---
Be aware that it may be the scanner itself that is defective.
If you purchased "used" or as an "incomplete return" and cannot get it to work with the software that Vivitar provides through their website, then the hardware may be at fault.
by neely
by neely
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending