Discussion Locked

WD 7200RPM HDD in Older PCs

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've seen this once before, and don't like it. Installed a 7200 RPM drive in an older PC (Pentium & Pentium II) and on a cold start, it comes up with a Primary Disk Failure. After reboot, possibly several tries, the drive comes up and functions properly. Short shutoffs don't experience the problem. Only after the PCs are shut off for an extended period of time, ie 8 hours or more, does this happen. Refrigerating the system, does not change the boot problem, ie it doesn't affect the PC at all. Does anyone have any ideas?

9 replies

by aclark

Try delaying the boot proccess in the BIOS. Under "IDE Drives" you usually can set a delay (in seconds), to give the hard drive a chance to spin up to speed. If the bios is really old, this feature may not be an option.

by tci_cto

This is a timing issue, the drive needs to either slow down the speed that it is sending it's IDE identifier strings, the bios needs to be configured to read the IDE channel identifiers faster... try getting the bios to autodetech the drive properties and then write these down and configure the bios for a manual assingment of the drive parameters.

by cdobbin

I've had problems using WD drives in P2 machines, if I tried to set the drive as a master on either channel it would not detect the drives, BIOS was set to auto detect but still no go, it was only after someone told me to try setting the drive to cable select did it detect them ok. Just for the heck of it set it to cable select and see what happens.
And just for the record I have found that using two WD drives on the same channel does not seem to cause this problem, you can set em master and slave and the seem to work fine, only when using one drive per channel did I have problems. It may have had something to do with the BIOS of the PC as well.

This discussion is closed to new replies.