Discussion Locked

What if the CD-R and CD-RW on same contr

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We are having problems with a CD burner (Sony) that quits burning after 2 to 8 seconds of data, then the system locks up. The CD-R and CD-RW are on the same controller(2). The hdd is on controller(1). Does it make a difference? Should the burnerbe on a controller by itself?

9 replies

by jon_w31

If you are copying cd's on the fly then the re-writer is best on seperate cable to the cdrom.
Is the re-writer 'Burn Proof'? If not I suggest you close all running programs before attempting to write data. (ctrl+Alt+Del close everything except Explorer + Systray.
Try re-installing re-writer software/drivers.
Does your system meet the minimum spec to run the re-writer?
Do you have the correct drivers for you operating system.(May need specific drivers for 'WIN ME'
Hope this of some help

by maimiea

We have test the writer several different ways - same cable as CD-R, same cable as HDD, seperate cable - they all worked for us (the technicians), but not for the user. We tested quite a few burns to make sure we were not doing anything wrong -The only thing the user was not able to do was burn a "burned" CD. So we now know that you can pretty much set up a burner any which way, but we never found out which was the best.

by dmiles

The mostly likely setup would be to put the cd-r on first controller with the hardd drive and designate as slave
Install the cd-rw on the secondary controller with cdrom if present and set your jumpers on the cd-rw to master.
Enter the CMOS control panel and make sure that you have both primary and secondary fifo controllers enabled.
Update the drivers.
Hope this helps

by maimiea

We have test the writer several different ways - same cable as CD-R, same cable as HDD, seperate cable - they all worked for us (the technicians), but not for the user. We tested quite a few burns to make sure we were not doing anything wrong - The only thing the user was not able to do was burn a "burned" CD. So we now know that you can pretty much set up a burner any which way, but we never found out which was the best.

by craig shepherd

If it's only taking that long before it locks up you've probably got a buffer underrun error.
This occurs when the computer can't read from the source as fast as it's burning to the CD.
Having both drives on the one cable shouldn't have an effect on that.
Try slowing down the burn speed and check the transfer rate of the source.

by maimiea

Yes, we found out that it did have a buffer under-run. I have two burners on two personal systems and they have no problems with being on the same cables.

by tocolote

If you're making copies of CDs, then you should have the CD drive you record from on a different controller than the CD drive you record to. It does make a difference for speed.

So if you have a marginally capable PC (Look at the CD-R/RW manufacturer specs) this could be creating your problem.

This discussion is closed to new replies.