10 replies
by pierrejamme
First of all, your RAM must be PC66 and it is hard to find.
Secondly did you check out www.simmtester.com? Download a free program called docmem20.exe to make a boot disk memory checker.
Good Luck.
by chickenlegs
by 14me24u
by chickenlegs
by ajarwey2001
Firstly you may be mixing the memory. It is not advisable to have a tin and gold pin-etched memories on the same board. Check what capacity of ram the board can support. If the board can support 100MB of ram and you go beyond that the balance ramwill not show. Consult your system board manufacturer or the computer manufacturer at their website.
Andrew
by chickenlegs
by thechas
First of all, many of the older motherboards are very picky as to the configuration of the DIMM modules. I have seen them report 1/4 and 1/16 of the RAM on a "modern" DIMM.
Numerous motherboards only work with double-sided PC-66 SDRAM modules, and nothing else.
Also, there was a TechRepublic article on memory issues and the Intel 430TX chipset.
I don't remember the specifics, but I believe that if you have over 64MB of RAM, the cache memory is disabled!
I have experiance many memory modules that will not work together.
I keep a PC-100 double-sided DIMM on hand because I have yet to find a motherboard that it will not work in. (except a few with 32MB SDRAM limits!)
2nd, Just because Belarc says you have an Intel board, does not mean that Intel built the board.
The model numbers you provided are similar to Intel numbers, so the board could be an OEM. If so, you need to identify the make and model of the original PC it was in for support.
Here is a link to Intels motherboard archive;
http://support.intel.com/support/motherboards/desktop/archive.htm
Remove any spaces from the pasted link.
You can verify who made the motherboard from the tools at www.motherboards.org
or www.wimsbios.com
Chas
by thechas
I had an ASUS 430TX chipset motherboard with 3 DIMM sockets.
If a 64MB DIMM was in slot 1 or 2, slot 3 was dissabled.
My point is that many of these older motherboards had some strange configuration limits.
Chas
by ajarwey2001
Hello,
There is another point to consider when troubleshooting your problem which I overlooked today. You should check up the settings of your computer(cmos/bios setup at begging of system startup- mostly delete or F10 keys) to see if the systemallows multiple memory.
But I think the main problem is you are adding more ram than necessary so setup may help.
Andrew
by chickenlegs
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending