3 replies
by mkstein6 Accepted solution
by dutt03 Accepted solution
by hal 9000 Accepted solution
When you see the [b]Inspecting Your Computers Hardware[/b] that is generally associated with the Windows XP Initial install sequence and not a Boot up problem at all.
Can you see the POST Screen telling you what Hardware is installed in the way of CPU, RAM and HDD/s? Or do you see some makers Splash Screen saying HP, Dell or whatever and something like press F2 to enter BIOS?
If you can see the POST screen you have a hardware problem and there are a few things that you can do to recover from this the first is to make sure that everything is still actually connected and working so you'll need to at the very least Enter BIOS and see what is being shown as available for use. If you see the right CPU, RAM and HDD's it's then safe to take the next step by booting off something like the Ultimate Boot CD available for download here
And then run some diagnostics.
However if you can not see the CPU, RAM or HDD or they are reported incorrectly you'll have to open the case and start to check connections to make sure that everything is correctly plugged in. Remember that there are [b]Static Sensitive Parts[/b] inside the case so you'll need to take some basic static control steps which involves placing both of your hands on a metal part of the case for a short time and being careful in the clothes you are wearing and the surface that you are working on.
Also if you have an ATX type Power Supply you'll need to disconnect the power lead to prevent electrical damage to the internals if you drop something as there is always power present on the M'Board.
Another thing that you could check is the Displayed Date & Time in BIOS if that's wrong by a large amount of years the most likely thing is that the Battery has gone flat and needs replacing. On most M'Boards these are a button battery which is a Lithium battery with a code of 2032 and are available from most places that sell batteries.
If you need to change the CMOS Battery make sure that you have disconnected the Mains lead and allowed the unit to stand for a few minutes to discharge the Capacitors before attempting to remove the Battery. If you drop it on a powered M'Board you'll damage the M'Board by shorting out components.
If this is a Note Book computer you have some very different steps that you'll need to take but without more detail there isn't much else to add here as there are just way too many variables.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending