Discussion Locked

What's Eating My Hardrive?

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having problems with my hardrive developing bad clusters. It seems to keep accumulating more everytime I scan it. It all start with the first hardrive(Quantum Bigfoot 12GB) I had in my computer witch developed bad clusters in key areas that it crashed the system and could not be revived even with fdisk. So I brought a 20 GB Fujitsu and it started to develop bad clusters the first time I scan it with mircosoft disk. I also had no software on the computer except Windows 98. I've also ran the most up to date virus scans on all my software and it says they're clean. I read low level formats can cure the bad clusters sometimes but I would like to Know the cause. Could this just be bad luck with hardrives or is it something else. Please Helpany information on this problem is greatly appreciated.

11 replies

by magetower

I would start looking at a possible controller problem.

If you have access to another computer I'd plug the HD into it and test it there.

by mckaytech

I think the probability of having the same problem on two different make/model of hard drives is very, very low so I would agree with the first answer that you should be looking for a problem in some other component.

In addition to the controller, I would be looking very closely at the power supply and, perhaps, the motherboard BIOS settings related to power management. Or maybe there is some environmental factor like too much heat, mounting the hard drive upside down (most can be mounted in any direction except upside down).

paul

by grbeckmeyer

This is probably not the answer you want to hear, but in my experience I have never seen a Bigfoot drive last longer than a year without developing problems, and around my office we use Fujitsu's as paperweights. I personally haven't used Fujitsu'sso I just take other's word to stay away from them. I would stick with Western Digital, Seagate, or Maxtor.

by jankerson

I think you should take the system into the shop and have a hardware check done on it.

Could be the power supply or the motherboard. Maybe a short somewere.

Take it to the shop.

by tocolote

Could be a power problem with your AC or the computer power supply.

If you have a lot of power surges (lights flickering), brown-outs, or bad grounding this can cause problems with computers.

Check your outlet for proper wiring. You should beusing only 3 prong outlets for computers.

Buy or borrow a good UPS and plug your computer into it. The UPS will go into alarm if/when you have a brown-out (Your computer will still operate with below spec AC voltage, but it can damage components) and then you'll know that's the problem.

This discussion is closed to new replies.