Discussion Locked

Where can I find a driver for cd/rw

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Someone recently gave us a Sony Spressa i.link crx120e/x. Unfortunately they did not give us the software that goes with it. I have downloaded demo software called Nero and was told that a driver was not needed. I have not worked with this type of hardware before and would appreciate some help.

Thank you

11 replies

by william jay

Sony provides all drivers and such on their websites. Since the drive is now wo years old, most software for amking CDs will use it, (ie: NERO or Roxio Easy Cd and DirectCD), so what is the trouble exactly?

by luckyp403

The trouble is that I can not get my computer to recognize the cd burner. When I look under settings for the system, the curner is not there. I downloaded nero and that works fine.

by vatsaldesai

Try searching for the driver on Driverguide.com.
You will be required to register (ofcourse for free) if accessing for the first time.

by thechas

You do not need a driver persay for the CD drive under windows 9x or newer.
The driver that comes with many CD rom drives is for DOS mode.

What you may need, is to update the IDE busmaster driver for your motherboard / chipset.
This is very true under W98.

Also, make sure that the IDE channel is enabled in BIOS settings, and that the drive location is set to auto-detect.

Double check the drive setting jumper on the back of the drive(s). If there are 2 drives on the channel. 1 must be set to master, the other to slave.

by serg meister

I agree with answere 4, but if yo uhave installed the CD-RW & you can open My Computer & see the drive plus actually read from the drive(insert disk & see) then you are OK to Burn.
With Nero, under programs/Nero it has a NERO Toolkit - Nero CD Speed & Nero Drive Speed are used initally to test the Data transfere speeds of the Drive. Once you have copleted those - it's just a question of placing a blank disk in the drive - then using Nero to tell it what data you want burnt onto the drive (Keeping in mind you have a limited version of Nero - You might want to invest in the full version).
Good luck hope this helps.

This discussion is closed to new replies.