Discussion Locked

which is better uata 100 or udma 100?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have looked every place i can find to find out which is better an "ultra ATA 100" hard drive or an "ultra DMA 100" hard drive.I have found out that these may be the same thing, but can never find out for sure.

confused
thank you
dlrife@yahoo.com

9 replies

by mskiproductions

I concur with the second answer, Ultra DMA 100, Ultra ata 100. are identical, the "100" refers to the transfer rate (which theoretically is 100Mb's per second). However, if you can, try to save yourselt a bit of money by buying an Ultra ATA 66 drive, as no matter how much they try to tell you Ultra 100 is faster, all tests show that there is little difference between the old 33Mb/pr sec disks and the 100Mb/pr sec disks, let alone 66 Vs 100. Also, remember your motherboard has to support the higher speed drives for them to operate at thier 'Theoretical' maximum speeds, and that if you have more than one device attached to one IDE cable, BOTH devices will operate at the speed of the slowest device.

I hope this is of help to you.

Matthew Shine.

ComputaCenter, Europe.

by gh0stmaker

If your pc supports an ata 100 hd controller & your using a 7200rpm hd u will notice a large performance differenc over 33 or 66 controller & hd. Remember the hd cable should be 80 pin & not 40. I have seen pc oem manufactures ship 40 pin cables w/ ata 100 hd & that will run like a 66mhz hd & nullify the controller & hd.

This discussion is closed to new replies.