Discussion Locked

why can't I use my modem?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 'installed' a new modem from Zoom. It's an internal 56K Duelmode. Did all the proper things........I thought! When I try to log onto the internet.....my IP says the modem is not responding, or has not been installed. Is there a secret to the installation? A 'teckie' told me to install the software first, then the modem. Didn't work. Now what do I do?

7 replies

by captain krunch

Let's take it one step at a time - did you read the instructions that came with the modem? Start by opening "control panel" then open the "modems" file folder, remove the modem or you can remove all the software that you loaded thru add/remove software and then remove the modem thru add/remove hardware. Now power off, open the case and pull out the modem. If it is a Zoom Internal Dualmode model 2919-00-00L-PC there is a jumper that has to be set to tell it whether it is Plug and Play or NT.
The proper setting should be in the documentation that came with the modem. Once you have the jumper in the correct position for your OS (Win2K?) reinstall the card, power on the machine and Windows will recognize it the Install Hardware Wizard will start, when it asks if you want it to search for the correct driver click on "Have Disk" and direct it to the software that was supplied by Zoom. Hope this helps.

by mztedibear

I found the proper setting for the jumper.......someone had set it for a no plug and play setup. I didn't think that I needed to check the jumpers as it didn't say anything about windows 98 SE. Thank you for suggesting that I take a look at the jumper setup. I had no more problems on installing it.....your suggestion was a winner!

by opatzg9

With internal modems occasionally you run into a problem where the serial ports are reserving the IRQ's which make it work. I'ld try disabling your com1/serial port1 in bios, remove the modem through the control panel and reinstall it. I did not see what operating system you were using or what age your machine is but Make sure this port is not in use by your mouse if you have the older trapazoidal shaped connector it may be here.
If so Make your modem com port 2 after disabling serial/com 2 in bios.

by mztedibear

I had tried several times removing the modem through the control panel and reinstalling. That didn't help at all. I checked the ports and only #1 was being used. It ended up being the jumper was improperly set. But I do thank you for your suggestions.

by curtis

Of course this all depends on your OS but ...
After installing a new modem you need to open the dial-up networking folder (win9x) and right click on your internet connection, then choose properties.(you may get an error stating that it can't find your old modem, just click ok) Near the bottom of the properties page is a drop down box that says which modem will be used to dial the internet. Since you replaced the modem that was there with a new one, you will need to choose the new one from the drop down list. After choosing the currently installed modem for the internet connection, it should work properly.

Hope this helps

by mztedibear

The old modem had already been removed and the software as well. So it wasn't a conflict with the old modem that kept the new one from operating. Someone had reset the jumpers to turn off the plug and play. I corrected that..........and it went well from there, but I do thank you for your help.

This discussion is closed to new replies.