Discussion Locked

why does display stay in standby mode?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've got a brand-new PC with a MSI motherboard,Phoenix BIOS, 256Mb of RAM, a Maxtor HDD, a LG CD-burner, a floppy drive, and a built-in Display Adaptor. When I power it up, the fans run fine, and the power, HDD, CD, and floppy LEDs come on. The CD LED just flashes a couple of times and goes off. The HDD LED goes off after about 5-10 seconds. The floppy LED never goes off. The monitor never comes out of standby mode. I unplugged all drives with no change. I installed a known good Display Adaptor (which I'm using right now), but the monitor still never comes out of standby mode. There are no beep codes.

Anyone got any ideas? Could this be a power supply problem? Any help would be greatly appreciated....

3 replies

by mlacombe

Try another monitor, reseed the memory and the processor. If you bought it with 2 sticks of RAM pull 1 stick out, with a stick left in slot 0, then swap the sticks and reboot if that didn't work. Make sure you have the power unplugged while you do that. If you only got 1 stick, you should go buy another stick of RAM. At the VERY least another 256 meg chip. Windows XP won't run very well off 256 meg's anyway. Other than that, you're probably looking at a bad motherboard/processor/ram or a combination of those. Do you even hear the posting Beep at the beginning of the bootup?

by jodym1

I recently had an issue like this. If you take the motherboard out of the case will it boot? Its possible that something is shorting it out. Mine happened to be the spacers. I didn't have any beep codes either then found out that I had to have speakers plugged in to hear the annoying voice saying "System failed CPU test"

by hal 9000

If the floppy LED stays on constantly the lead to it is the wrong way round and this may be causing the system to hang.

It's possible that the BIOS is set to stop on any errors and this would constitute an error so that the unit is never actually starting. Try disconnecting the Data Lead from the Floppy and restarting the unit. If that has no effect you'll need to clear the BIOS by changing a Jumper for a few seconds generally you need to move the CMOS Jumper from pins 1-2 to pine 2-3 for a few seconds and then reset the jumper to pins 1-2 this should be in the User Manual that came with the System or M'Board. If you can not get any joy look up the Model of the MSI M'Board on their Web Site and download the manual for the board to find out the proper way to reset the BIOS. You should find the required Info here

http://www.msicomputer.com/index2.asp

After you have done this you'll need to reenter the BIOS Setup to at the very least set the Time & Date.

Col

This discussion is closed to new replies.