Question Locked

Why Will WinXP Not Load From/On SATA?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Building a special computer for a lab technician. Haven't built one for a couple of years. Trying to load WinXP. After files have copied from CD (1st reboot during setup), computer re-starts and goes right back to the setup again. Why is this happening? I do not wish to use RAID. Now I did load (just as experiment) Win2K and it loaded, but not recognizing the entire drive size (roughly half). Do I need to load the RAID drivers or now since I have Win2K loaded, could I just upgrade from Win2K to WinXP with no problems, or will the same thing happen again and still have to load separate drivers? Could this also be a BIOS adjustment problem?

Gigabyte MA785GM-US2H
AMD-Phenom II X2 550
Ultra LS500 500W Power Supply
2 - 320GB Seagate Drive SATA 3GB

3 replies

by ---tk---

after you load the OS, and it does that first reboot. Jump into the BIOS, and select boot to HDD first. Or when it prompts you to hit a key stroke to boot to CD... Don't hit anything....

by jamesrl

The core XP install doesn' have generic SATA drivers. So when you get the point where the install asks if you have a RAID or other special interface you need to put a diskette in the drive that has your SATA drivers on it. It will copy those drivers onto the disk as you install.

James

This discussion is closed to new replies.