Discussion Locked

WIDE SCSI vis-a-vis ULTRA WIDE SCSI

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to replace my wide scsi with ultra wide scsi without reinstalling NT but after succesfully mirroring from the wide scsi onto the ultra wide scsi, I broke the mirror and attempted to boot but kept getting the error: " A disk read error occured. Insert a system diskette & restart the system". Tried another ultra wide scsi and got same error message. However, no problem encountered when same thing was done using a wide scsi drive. Please help With the specifics of why it's impossible to mirror from wide scsi to ultra wide scsi and start the system with the mirrored ultra wide scsi. Server is HP Netserver LC3(NT4 Spk6a), using hotswap drives. Thanks.

5 replies

by djent

You dont mention which SCSI controller is used. some LVD drives have a termination jumper, if your controller is not an LVD compatible version you must provide termination (set the term jumper). Both Adaptec and Seagate have detail explanations of LVD configs on their sites. UW requires an LVD controller, LVD cable with termination and LVD drive.

by wlbowers

Try swapping the scsi id's. Make the new boot drive the scsi id of the old boot drive.

Good Luck Lee

This discussion is closed to new replies.