Discussion Locked

Will not power up.

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just replaced the power supply in my ATX, Celeron computer. When I press the On Off button the system will attempt to power up for about 1 to 2 seconds and then go off. There seems to be power to the motherboard because the Power to SIMM LED is lit. The switch is attached to the motherboard by two small wires. Could the problem be the switch or did the old power supply cause damage to the motherboard? I tried disconnecting all of the drives. The results was the same.
Any and all help appreciated.

12 replies

by dmiles

It reads as though you have a voltage problem,the problem could be the wattage of the power supply is not compatible with the system.
Did you upgrade to higher watt power power supply?

by dmiles

It reads as though you have a voltage problem,the problem could be the wattage of the power supply is not compatible with the system.
Did you upgrade to higher watt power power supply?
Check the swith connectors to make sure that they are orientated correctly.
Listen for a whistle sound,which will indicate a power supply problem

by ccinkc

Thanks the the reply.
I switched the power supply for one with the same wattage (250). Wires from switch to motherboard are the same as they were when the system worked. ???

by albert franco ii

I have replaced at least a half a dozen CPU/motherboard combinations and Power Supplies. It seems relaively common that when the supply bites the dust it takes the CPU and/or motherboard with it.

Try another power supply. Make sure all connections are solid. (i.e. cards and cables). If that doesn't work then one or both are damaged.

If possible try the CPU in another board with a good supply. It's not likely that a bad CPU can damage a good board. I would be careful plugging a good CPU into your motherboard as a bad motherboard CAN damage a good CPU.

If your CPU is good the mother board is obviously bad. If your CPU is bad I would just consider both the CPU and motherboard as bad. (Unless you have a spare CPU that you don't mindrisking).

by thedrummer2006

This can be caused by a few things. I built a computer for a buddy of mine and the power switch was bad. It caused this. The power switch on atx cases are momentary pushbuttons normally snap action. when you press it it clicks. It makes and breaks aset of contacts to tell the mother board to turn on. The newer atx motherboards take care of turning the power suppply on and off so if the power supply is turning on and then back off you have probably got a bad pushbutton, bad connection, bad solder joint, or a piece of hardware that is failing. Memory can cause this. I have seen memory chips cause this also.

A few things to try.
Best of luck.

by pete400

I had a classmate build a new computer that wouldn't powerup. We took the motherboard out and laid it on a book and it booted OK.
Replacing it and putting the screws in, it wouldn't boot. Putting the screws in 1 at a time, found one causing the problem. It seems that it had a small fiber washer on it. Replacing it with a different screw fixed the problem. Go figure.

This discussion is closed to new replies.