Discussion Locked

Win 98 will not identify mouse

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

A new installation of Win98 (reformatted HDD)fails to identify a mouse on Com1 or Com2. On startup, 2e8 & 3f8 show as "found". The BIOS has onboard com1 and Com2 Serial ports enabled. The control panel/system/devices show 2 X com ports BUT no mouse. I have tried another HDD with win 95 loaded with no success. This all leads me to a motherboard fault.

I purchased an ISA serial card and configured com 1 and 2, then disabled onboard ports, but still no luck. Has anyone any suggestions with what should be a simple problem to overcome. Yes, I have tried various mice. Unfortunatly this GA- 6VA7 motherboard has no PS2 port, or USB onboard.

5 replies

by thechas

Are any of the mice true serial or specifically serial / PS/2 combo mice?

Many of the new mice out there no longer function as a serial mouse.
If the mouse is USB / PS/2 capable, I all but guarantee that it will not function on a serial port. Even with the adapter.

The problem is that the firmware in most new mice no longer contains the legacy code to communicate over a serial port.

Next, once you have a true serial mouse, you may need to install it's specific driver, or the generic Microsoft serial mouse driver.

Chas

by sgt_shultz

if you are sure the problem is not the mouse (like, it works fine on another pc)...then look for cabling issue (motherbd to db15 connector)?
go into Add New Hardware, try adding the ports manually...check for conflict with modem or other com1 com2device: iobase, interrrupt? like, touchpad, internal modem, powerchute ups cable...?? (take out add-in serial port card for this part) check in device manager, see if any devices are using the iobase and interrupts normally reserved for com1, com2? maybe configure the serial card you bought to use other interrupt, io base than standard com1, com2?

This discussion is closed to new replies.