Discussion Locked

Win2k and Scanjet problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have recently upgraded all my workstations and server to Win2k. It went great and I've had very few problems. The biggest problem is with trying to get 2 HP Scanjet 5100c's to work with Win2k prof. I've downloaded the updates from HP but when Itry to run them I get the error that I must have administrator rights to run the program in win NT. I've tried logging onto the machine locally as administrator and logging onto the network as administrator and I STILL get the same error message.
When I try to manually install the scanner from the drivers already in Win2k it begins the installation and then halfway through, restarts the whole machine, and of course doesn't work. This is crazy. It should be such a simple install, but it's kicking my butt. HELP! Who's done this already and has the solution?

4 replies

by eyounes

Hello,
are you the systeme administrator. If so use the username and password that gives you administration rights on all the network not only on 1 station. Where is the HP connected on ur server or on your workstation?
Anyway, what I would consider is to always connect it to the server and add the HPPrintServer on ur server then it will work. But once again u have to have the system Administrator rights.
Good luck.
Elie

by Former member

Yes, I'm the admin and as stated I tried logging into the system, onto the network as administrator and it still does no good. I still get the error that I must have administrator rights. The scanner is connect via parrallel port to a workstation.

by Former member

Point value changed by question poster.

by Former member

This question was closed by the author

This discussion is closed to new replies.