Discussion Locked

Win98SE install error..STUMPED

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've got a new quantum (maxtor) lct20 10GB Ultra ATA 100 HD I'm trying to install in an older K6 300 Wintech (crappy) machine. The mobo is running Award BIOS but can't tell any more about it. The HD is detected fine by the BIOS and I use a Win98 floppy to load the CD and copy the Win98 directory to the HD (brand new formated w/ FAT32) but when setup runs the machine hangs right after scandisk when it says "copying files needed for windows setup." I think this must be an issue relating to theolder mobo not being able to handle ATA 100. The weird thing is that even with UDMA disabled in BIOS I get the same error. I've tried every other trick I can think of just for S&G, swapped memory, removed hardware all to no avail. Any suggestions?

4 replies

by matthew hansel

I assume you have one of the UltraDMA cables for your drive? And that you LBA mode enabled on the BIOS. Have you tried setting up the hard drive in multiple partitions (just for S&G) to see if the system will copy the files? Also, are the hard drive and CDROM on the same channel? If so, change that to having the hard drive and CDROM on their own channels. After booting, redo the FDISK and try formatting the drive FIRST and then copying the files. I am including a link to Maxtor's website - they recommend when using UltraDMA, to set the drive to cable select. Check it out. http://www.maxtor.com/quantum/support/hdd/fireball_lct10_support.htm
Let me know if that helps.

by it_cowboy

Check out this link...

http://www.ping.be/bios/index.html

over the last couple of years, BIOS has done some really funny things to me. if its an old machine (over 4yo) its possible that the hdd you are installing is not detectible, the size at least. get the latest bios for your motherboard. dont go looking for bios flashes at the bios manufacturers site, go to the motherboard manufacturers site.

by dean

Have you tried disabling ATA100 on the hard drive and forcing it to use UDMA 33? In order to do this you need to obtain the utility from Quantum (i guess its maxtor now). Once you have the utility, you boot into straight dos (use a dos boot disk) and run the utility. I have had many problems with modern drives and older motherboards and disabling ATA100 usually helps.

by liz lagrotteria

I had the same problem when I was working on a user's PC, trying to re-format/re-install. Install bailed out at the same point. He had turned virus protection on from the BIOS. I disabled it and was able to install.

This discussion is closed to new replies.