Discussion Locked

Win98SE install error..STUMPED

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've got a new quantum (maxtor) lct20 10GB Ultra ATA 100 HD I'm trying to install in an older K6 300 Wintech (crappy) machine. The mobo is running Award BIOS but can't tell any more about it. The HD is detected fine by the BIOS and I use a Win98 floppy to load the CD and copy the Win98 directory to the HD (brand new formated w/ FAT32) but when setup runs the machine hangs right after scandisk when it says "copying files needed for windows setup." I think this must be an issue relating to the older mobo not being able to handle ATA 100. The weird thing is that even with UDMA disabled in BIOS I get the same error. I'm not able to use an ATA cable due to the age of the motherboard. I've tried every other trick I can think of just for S&G, swapped memory, removed hardware all to no avail. I'm beginning to think that a PCI ATA controller card is my only choice. Any suggestions?

12 replies

by sales

maybe the virus detection is enabled in cmos? If not you can use a Promise bios controller card and still use the onboard IDE ports. I have one for 25 bucks if you want it. it will take up 1 ISA slot

by better_be_good

I cant understand why you are copying thw win'98 dir to the drive? It may install faster that way, but there is no need to do it. Try booting from a win'98 start-up floppy disk and choose start computer with CD-ROM support. Then go to your CD dir (prob E:) and type setup, this will install from the CD-ROM. Its worth trying this before anything else!
Hope this helps you.

by buffalodan

Also, you may be able to use MAXBLAST hdd utility for this system.

I once installed a 20gb hdd in a students gateway 486/66. I used maxblast, and installed win98se from cd without a problem.
(Slow as all heck, but it worked)

Maxblast is a Bios Overlay utility, and will process interrupts bound for hdd bios, basically, it can make up for the shortcomings of your system board bios.

You should be able to download this utility directly from maxtor's website, might be cheaper than buying new hardware.

good luck...

by systemboard

i just recently had the same problem with a
friends machine it would freeze when i would
try to install win98se and would do so right
when the copying files would start it would
say 29 minutes and stop the problem with his
machine was his RAM he had a 128 stick that
was reading at 64 this seemed to be screwing
up his computer pretty bad check your RAM
before you go out buying other stuff

This discussion is closed to new replies.