Discussion Locked

Windows 2000 Pro Diskette problems

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a HP Vectra VL400 computer with Win2K Pro
installed. I recently tried to install a digital camera
but was unsuccessful. It would not load the USB Mass
Storage Device driver so I decided to abort the
installation. Unfortunately, after I did that, the system
would not recognize the floppy disk drive and it wouldn't
show up in the "My Computer" window. I went to the device
manager and uninstalled the floppy drive and then had the
system dectect it. The system did detect the floppy drive
but it gives a message saying that "The software for the
device was installed but may not work properly" Code 1. I
have no idea why this happens. I have rebooted numerous
time but still no luck. Any help would be appreciated.

1 reply

by rdschaefer

Without more info I can't be more specific but the most likely cause is an IRQ conflict.
I would uninstall anything that says USB and the floppy again, shutdown (complete power-off not just restart) and see if that fixes it.

Ralph

This discussion is closed to new replies.