Discussion Locked

Windows is unable to print test page

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a system that was running 98 and it will not print to a new inkjet either in parallel mode or usb. It will print in dos, When I try to print it says" WIndows is unable to print test page" Tried printer on another system and works fine. Did all the usual blew out driver, comber registry, etc. Then tried a winME upgrade and still get same message. I may have to reload system if I cannot fix this.

7 replies

by dmiles

Before you reload the system try this and see if it works
Open the CMOS control to the Bios and look under configuration ROM PCI/ISA in the right pane you will see Onboard Parallel Mode:
change to ECP/EPP and try to print test page.

by j_spears

I ran into that same problem under 98 with a Lexmark 3200. Changed the port to ECP, still nothing. Ended up having to delete the existing port under 98 and allowing it to do the PNP detect. Still no luck until I seen in the printer specs that it required a DMA channel. Reconfigured the resources for the port and had no problems.

by meddjay

Check the power cords and the plugs, then uninstall, then look somewhere inside your printer for a reset button...it's there..you just have to find it. Then reinstall and you should be ok. Hey...it worked for me.

This discussion is closed to new replies.