Discussion Locked

Windows NT Atapi

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Mix ATA33 and ATA66 on same chanel. Duplex HD (ATA66) & Tape (ATA33) Chanel 0 and HD (ATA66) & CD (ATA33)chanel 1. ATAPI stopes responding on tape use.

3 replies

by gbworld

My first suggestion would be putting the two ATA66 devices on the same wire and the two ATA33 on the other. The primary reasoning here is that you are potentially slowing down your two hard drives with the other devices being slower. This, by itself, unfortunately will probably not solve your ATAPI problem with the use of the tape drive.

You may also have to tweak the ATA66 BIOS for the tape device. I had some problems with an early ATA66 BIOS and one of my hard drives that was solved with aBIOS upgrade. Apparently, there was a tweak that solved the problem prior to the upgrade.

Another possibility is to look for newer ATAPI drivers and/or check the tape drive manufacturer's site for any known issues. If this is an old tape drive, good luck on this one.

I am still trying to mull over what would cause the ATAPI to fail on this one. As this is ATA66, my best guess is still the ATA66 BIOS. However, without any further information, I am grasping at straws.

Gregory A. Beamer
MCP: +I, SE, SD, DBA

This discussion is closed to new replies.