Discussion Locked

windows won't recognize H.D.

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi - I have an E-Machines 600. I recently tried to add a H.D. to the secondary channel. this machine uses cable select so that is how I set it up. The BIOS recognizes the drive butit does not show up in windows. I have tried setting the jumper to master - same result. any ideas would be appreciated. I have tried changing the cable same result.
Alex

9 replies

by thechas

New hard drives come from the manufacture in a "raw" state.

What you need to do, is partition and format the drive before you can use it.

I recommend booting from a startup floppy, and running fdisk from DOS.

You will need to select the second drive after you enter the program.

There are 2 ways to go about partitioning.
Setup the drive with 1 Primary DOS partition, and 1 or more logical drives in the extended partiton.
Or set up the entire drive as an extended DOS partition.

Ifyour existing hard drive has more than 1 partition, you may want to use the 2nd option in order to avoid having the "D" drive become the "E" drive.

The drive letter of your CD and removeable drives will begin at the next drive letter above the last logical drive on the new drive.

For more information, check out the partition article at www.aumha.org
And the fdisk page at fdisk.com www.fdisk.com/fdisk

Chas

by celectronics

this H.D was being moved from another machine - I should have mentioned that. by itself, on the primary master it will boot fine. any suggestions
Alex

by edsdave

Assuming that you are on one of the Windows home O/S's, i.e. win 95, 98, ME, go to the Control Panel, System, Device Manager, Hard Disk Controller and see if the Primary IDE controller is (dual fifo). If not then the controller driver not correct for running 2 hard drives.

by thechas

Ahha, that is a gottcha for my first answer.

1. Some brands of hard drives do not get along with each other.
Try placing the new drive on the secondary IDE channel.

2. Does the drive have a "drive/bios" overlay program installed.
These programs are used to "fool" the BIOS on older PCs so that they will allow you to use a large hard drive.
If one of these programs is installed, you must have it installed on all drives in the PC, or the drive with the program is not accessable.

Chas

by nook

If the second HDD is formatted with NTFS, Windows 9x and ME will not be able to recognize it.

If thats the case, you'll have to reformat the drive with FAT32.

This discussion is closed to new replies.