Question Locked

WinXP boot problem should be simple but has me stumped!!!!!

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Okay, I moved a client's hard drive from an old computer to a newer one I had around. Tried to boot it but past the bios it just gave me a blinking cursor. Tried a recovery console fixboot/fix mbr, still nothing. Started a repair install, when it restarted to continue, still the blinking cursor. Made a boot disk with a boot.ini
ntdetect, etc. and it booted back into the install and finished, rebooted still the blinking cursor. Used the boot disk and it loads into Windows fine. Checked to make sure the partition was active. Checked the boot.ini, etc., everything fine. Reboot and without the boot floppy in, still the blinking cursor!! Has anybody got any ideas on this? Boots fine with the floppy but not without! -Kelly

3 replies

by itorres

I hope someone has an idea. I have tried three different hard disks on an older Compaq Presario. They all were bootable from other machines and would start to boot the system, but the HW drivers would not be compatible.

Attempting a repair or complete install renders the drive unbootable. Partition data seems OK, folders and files are seen. fixmbr, fixboot don't help.

I have read some possibilities could be system trying to boot fron USB or other devices. Perhaps something to check out.

Good luck.

by animatech

booting with the floppy to windows then run "sfc /scannow" via command prompt.
Make sure you got the windows installation CD (As it will refer to I365 folder on the CD).
This will make sure that all windows files are intact.
Also check the bios boot order - just to be on the safe side as by your post it sounds like a corrupt windows file.

This discussion is closed to new replies.