Discussion Locked

Wire Schematic Cable

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a IBM 6549-40n monitor that was given to me. The problem is his dog chewed the cable in half and doesn't know where the connector is. So, I want to install a connector but don't know what wire goes to what pin...Thanks

4 replies

by alvarr

The wire colors don't match. I have GRAY,RED,BLUE thick wire and 6 small wires white,black,brown,orange,yellow, and green. This is not the type you can unplug from the back, is connected inside and to the board.

by richard_barsby

Hi answer 1 is ok if it uses a detachable cable if it does not then try the folowing,
the red,green,blue cables are the tv type cable ie coax the green maybe grey and are as follows:

1 = red inner
2 = green/grey inner
3 = blue inner

6 =red outer
7 = green/grey outer
8 = blue outer

if you are not bothered about plug and play then you may only need 3 more wires connected these are H-sync on pin 13 V-sync on pin 14 and a digital or sync ground on pin 10 to determine which colour is used for these is awkward you may be lucky and the monitor end might be marked on the pcb where the connector is fitted. If not the colours tend to be either yellow,brown,white for the syncs and black for the ground, some monitors need pin 5 tobe connected otherwise the screen is either very bright or blank if this does not help please email me.

Best of Luck

Rich

by alvarr

The wire colors don't match. I have GRAY,RED,BLUE thick wire and 6 small wires white,black,brown,orange,yellow, and green. This is not the type you can unplug from the back, is connected inside and to the board.

This discussion is closed to new replies.