Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had built my computer and got it to turn on, before adding a floppy disk drive. I must have pulled the power switch jumper lead out by accident and was wandering if anyone could give me any help on where to wire it in as i cant remember where it went. The case is a Casecom 7770 and the mobo is a MS-6577 VER: 2.1. Any help appreciated. Thanks.
2 replies
by luke.norris7 Accepted solution
Clarifications
by johnson.charles.c Accepted solution
on your mobo, look for a block of prongs, all together in groups of 2. Pwr will be at one end or the other, and will use 4 of the prongs (end to end). On some boards there is a gap of one prong for the Pwr like this ||.|
If your board is one of these, you can try JFP1.
http://h10025.www1.hp.com/ewfrf/wc/genericDocument?lc=en&cc=us&docname=bph07843
or the Front panel connectors on:
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00018887
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies