Discussion Locked

Wont boot, no BIOS/CMOS screen or Prompt

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

PC: Packard Bell Platinum 2010X
HDD: 2.0gb Maxtor
Pentium I 166mhz

Ok. Here we have the pc will turn on, black screen comes up. After a few seconds we get a single beep. Then the screen flashes and goes back to a blank/black screen. And nothing. I am the 3rd Tech to look at this PC and I believe the first 2 did a very poor job in that they gave only hardware support and didn't re-load the software. Unfortunatly I cannot get to the dos prompt to even attempt a reinstall. Nor can I access the CMOS options (The screen doesnt come up!) Neither will the win98 boot disk work either. I have also tried the PB Recovery boot disk and CD and that hasnt done anything either. How would I go about formatting the HDD and doing a clean restore from the CD from here? I CANNOT access the drive.

The cd-rom has been replaced as well as the HDD and the HDD cable.

Please, ANY suggestions are helpful here.

7 replies

by syscokid

In my opinion, it has to be a hardware problem. Why? Because the computer doesn't even know it's a computer yet. It is not passing the POST. I think you're looking at replacing the BIOS, and maybe the motherboard itself.

You could try first replacing the video card, and then the RAM, to see if either one of them fixes it.

Another idea, strip it down of all peripherals. If it then boots, replace them one by one until you find the culprit.

But I'm betting BIOS/motherboard, since it's not even passing the Power-On Self Test.

by mm212

Start by hooking it up to a different monitor. This is the most likely and easiest to fix. If the monitor isn't the problem, continue:

In order for a computer to operate (at all) it requires a processor, memory and video. It sounds like at least one of these is no longer functioning. My bet is the processor.

Typically, when your video board is malfunctioning, you will get a series of beeps. Same thing with memory. If a processor is out, you typically would get no beeps at all, possibly one.

So, yes, it's definitely a hardware problem. I'd start by removing, then reseating the processor, memory and video card. If this doesn't solve the problem, I'd begin replacing each component with a known good component.

by kloran-[thrawn34

The monitor was fine and checked out ok. Processor checked out as well. Ram was fine and detected.

One beep signals that the POST was passed. No beeps, or multiple beeps would signal a problem. I should have just said that the POST was passed. Thanks anyway.

by william jay

It definintely sounds like a hardware issue, though may be complicated by a viral infection. That said, and since the computer IS passing the BIOS POST, (as evidenced by one single beep as the BIOS passes control to the OS), the problem lies in video. Disconnect the monitor from the computer and reset to factory defaults by turning the monitor on, the light will go green if the monitor checks out, (the light will be amber if connected to a computer.
Open the box, remove the video card for a minute, then install it again, (better yet, put a different type or known good video card). Check the pins on the connector for bent or broken.

When the machine starts up, go into BIOS setup and make sure onboard video is disabled and that ega/vgais selected for startup. Save the settings and restart ...

If windows was fed inappropriate drivers for video, you may need to run setup again to straighten it out. of course, if the contrast and brightness controls are way down, then you may have full video, but it looks black ...

Hope this helps ...

This discussion is closed to new replies.