Discussion Locked

won't boot no screen

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
have a pc ddr 266 m841 motherboard when starting up no bios no screen and 8 beeps have tried different memory and JP1 jumper hopefully did it correct and have removed cmos battery for 8 hrs and still no boop. card has built in video & sound don't know if I can jumped and use a diffent video card till problem is corrected.

7 replies

by dmiles

The problem is the video card,if you are getting 8 short beeps it means that you have a bad video card.

If you have a vidoe card that can be installed in PCI or AGP slot then use it.

You can access the Bios,when booting computer at startup screen press the designated key to enter setup (view key in bottom left corner)
The motherboard manualshows details how to access CMOS configuration to disable the onbaord video and sound

by fenaikh

Hi

According to ami bios bee codes the video adapter is may be faulty. Try another video adapter card which usually when installed will disable the onbaord video adapter. In the otherhand built in video card usually use shared momery which isusing the system memory which makes the video adapter card the best.

http://www.ami.com/support/doc/AMIBIOS-codes.pdf

Good luck

Mohamed

Note1:
***Very Important NOTE *********
After you copy the URL a space or a %20 maybe gets inserted in the URL when you paste it into your browser. Delete any spaces or such characters from the URL for the page to be loaded.
***Very Important NOTE *********

by fenaikh

Hi

According to ami bios bee codes the video adapter is may be faulty. Try another video adapter card which usually when installed will disable the onbaord video adapter. In the otherhand built in video card usually use shared momery which isusing the system memory which makes the video adapter card the best.

http://www.ami.com/support/doc/AMIBIOS-codes.pdf

Good luck

Mohamed

Note1:
***Very Important NOTE *********
After you copy the URL a space or a %20 maybe gets inserted in the URL when you paste it into your browser. Delete any spaces or such characters from the URL for the page to be loaded.
***Very Important NOTE *********

This discussion is closed to new replies.